EMT Practice Test

1. Question Content...


Question List

Question1: Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Question2: What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

Question3: In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

Question4: Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

Question5: Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

Question6: Refer to the exhibits.
Exhibit A -

Exhibit B -

Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferredmember in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?

Question7: Exhibit.

Which conclusion about the packet debug flow output is correct?

Question8: Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Question9: Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

Question10: Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)

Question11: In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose two.)

Question12: Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

Question13: Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

Question14: Which two statements about SD-WAN central management are true? (Choose two.)

Question15:
Exhibit B -

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?